After gathering your supplies, apply a few coats of white paint to the wood plaque until covered. Allow to dry completely.
While the plaque is drying, you can begin cutting out the words and images from the "Letter to Santa" Design Space file linked above. Weed out excess vinyl.
Set the temperature to 300 degrees and use the EasyPress 2 to pre-heat the wood plaque. This step is super important because it helps get rid of excess moisture that may prevent the vinyl from adhering to the surface. After pre-heating, lay out the vinyl wording and apply light pressure with the EasyPress 2 for 40 seconds.
If any of the edges of the vinyl didn't adhere completely, you can use the EasyPress Mini to go back over.
Your Personalized Letter To Santa Wood Sign is now complete and ready to gift!